Factory Fog Light Switch

[Gluestick]

Rear chase / flood exactly what I’m after.

Sponsored

 

[FordOwner]

Rear chase / flood exactly what I’m after.

Here's the best post that summarizes everything you are looking for in my opinion: https://www.bronco6g.com/forum/threads/factory-fog-light-switch.22937/page-71#post-2015340

 

[Ddub]

Does anyone know for sure if M2DZ-11654-CC is still a good part number for a 2024? It’s the switch for front/rear fogs and mirror lights. Every where I look says 21-23 but I don’t see why it would have changed for 24. About to click checkout and wanted to be sure. Thanks

 

[BigHoof]

Ford says it fits a 2024 if that is the version of switch you want. Go to the actual Ford Parts site.

https://parts.ford.com/shop/en/us/electrical/switches/headlight-switch-front-p-m2dz11654cc

 

[Ddub]

Ford says it fits a 2024 if that is the version of switch you want. Go to the actual Ford Parts site.

https://parts.ford.com/shop/en/us/electrical/switches/headlight-switch-front-p-m2dz11654cc

Thank you!

 

[DriveAllNight]

I was thinking of getting the OEM switch with fog , and getting the lights for the mod bumper - does anyone know if the wires are there and connected to the harness for the 2024s ?
So if I bought the new switch would it basically be plug and play?

Or would I need to wire it and add to the harness?

Thanks

 

[NoSadLands]

i can verify the wires are the same!! success took me about 3 hours the hardest part was the torx screw that screwed into the bumper after the lights were installed

Did you cut and spice into the two wires? Been putting this off myself as well. Badlands modular bumper no front sensors

 

[tilebroncodude]

Did you cut and spice into the two wires? Been putting this off myself as well. Badlands modular bumper no front sensors

Yes I bit the bullet and I cut the wires about 3 inches shy of the harness. I soldered male crimp connectors to each one because I wasn’t sure which was right and which was left. I bought about 50 ft of wire that had both red and black in it that was weather proof. It was a pretty simple mod. I ran a ground back into the engine compartment I didn’t want to ground the lights anywhere close to the bumper.

 

[Ducati1098]

I was thinking of getting the OEM switch with fog , and getting the lights for the mod bumper - does anyone know if the wires are there and connected to the harness for the 2024s ?
So if I bought the new switch would it basically be plug and play?

Or would I need to wire it and add to the harness?

Thanks

Depends if you have front parking aid or not. Your signature says you have lux, which means the fog light connectors are already there at the bumper.

Sponsored