I fixed it. I found several different modules that each had a global window setting. It had to be enabled in every module. Thanks!Try the global window reset on each window - that fixed it for me (spreadsheet has it)
Sponsored
I fixed it. I found several different modules that each had a global window setting. It had to be enabled in every module. Thanks!Try the global window reset on each window - that fixed it for me (spreadsheet has it)
There is a "neutral tow mode". You use that instead of accessory mode. that should not have any timers.Is there an idle time setting that can be changed? I thought i saw somewhere that it was 30 min idle. I ask because for us that want to flat tow the 2.7 behind our motorhome the Brakes on the 2.7 are electric assist but it sounds like the electric assist shuts off around 30-40 mins and the brake bias in the suplemental brake system wont have enough power to apply brakes. i am wondering if its tied to max idle time even if engine is off.
That is where the problem is apparently showing up in neutral tow the electronic brake boost is timing outThere is a "neutral tow mode". You use that instead of accessory mode. that should not have any timers.
Somewhere back in the thread this subject was covered, it's not something you can currently change with forscan. It's possible to disable the speed limiter on an F-150 if you hardwire some connections going to those lights, but I don't know if it's an identical procedure on the Bronco. Would be worth checking into, I just haven't dug deep enough into the wiring and modules on mine to say if it's possible or not.I looked around and didn't find an answer. Does anyone know if the spotlights in the mirrors can be enabled at any speed? They turn off above 5mph stock. I was in FORscan earlier and all I saw was enable/disable. Has anyone tried yet or would I be the guinea pig?
They locked down forscan for MY22s?Your profile pic looks green. I think 2022s are having some issues with forscan
I'm having the same issues for writing to the IPC, it won't let me change anything there. I have a MY22.I think it's larger than just 22's I believe it was something that was either rolled out late in MY21 or a software update that they've rolled out recently at some point. Mine is a '21 that was delivered to the dealer back on 11-27-21 and I'm not able to change any settings in the IPC either.
Happens a lot with new MY. Ask the ForScan Devs for a link to the latest beta. The usually update these issues fairly quickly.I'm having the same issues for writing to the IPC, it won't let me change anything there. I have a MY22.
I've got a MY21 (delivered in November) and I'm not able to change any IPC settings either. I'm trying to add the factory fog switch and the IPC write errors out at 28% every time.I think it's larger than just 22's I believe it was something that was either rolled out late in MY21 or a software update that they've rolled out recently at some point. Mine is a '21 that was delivered to the dealer back on 11-27-21 and I'm not able to change any settings in the IPC either.
Doesn’t do anything. The safety Nannie’s are controlled by the PCM sending out a speed signal. We can’t get into that yet. Only option is a hardware mod to interrupt this signal at the harness.Anyone play around with the camera/speed settings?
There is something going on in Baja mode, which allows cameras above normal parking lot speeds...Doesn’t do anything. The safety Nannie’s are controlled by the PCM sending out a speed signal. We can’t get into that yet. Only option is a hardware mod to interrupt this signal at the harness.
The setting is “off-road”. That’s why it states “for off-road use only” when you’re in those modes. I bet there’s a way eventually to say the vehicle is in an off-road mode but it’s not so simple as of yet.There is something going on in Baja mode, which allows cameras above normal parking lot speeds...
This signal/setting is likely what we wanna find