No but it does the muffler shield if you turn it up too loud.Does it rattle your top any?
Sponsored
No but it does the muffler shield if you turn it up too loud.Does it rattle your top any?
Can you tell me where this diagram came from? I don't think I saw them in the service manuals or owners manual.
Here you go.Can you tell me where this diagram came from?
Oh yeah, I downloaded all your diagrams, I meant more like, where did you get them from?Here you go.
2021 Bronco Workshop ManualOh yeah, I downloaded all your diagrams, I meant more like, where did you get them from?
First make sure they’re open. Look like a 3 finger claw when they are. Must be lined up perfect. Can pull the top back a hair and peek down with a flashlight. May have to wiggle the panel a hair to get them to catch. Push directly on them to get them to click.Can anyone who's taken off the rear cargo panels and reinstalled share any tips for getting the two-piece snap clips to reattach when putting the trim back on? I can't get them to clip in for the life of me. I know one part stays attached to the body, the other to the panel but it's alsmost like they're not fulling lining up or something. The rest of the panel clips in fine, but I don't want it to be loose. Does it matter which order you reattach the panel? I have some replacements coming to see if this makes a difference. Circled the ones below in red from the manual I can't get in. Maybe @Ksjrb03 has some ideas?
That’s kind of weird I haven’t had any issues getting them to snap in. They have some flex to them after attached, so not sure if your comment on being tight is expectations? They definitely need to be lined up perfectly.Can anyone who's taken off the rear cargo panels and reinstalled share any tips for getting the two-piece snap clips to reattach when putting the trim back on? I can't get them to clip in for the life of me. I know one part stays attached to the body, the other to the panel but it's alsmost like they're not fulling lining up or something. The rest of the panel clips in fine, but I don't want it to be loose. Does it matter which order you reattach the panel? I have some replacements coming to see if this makes a difference. Circled the ones below in red from the manual I can't get in. Maybe @Ksjrb03 has some ideas?
Thanks- I’ll keep playing with it. Do you always separate the two pieces or just keep it attached to the panel and insert into the body? When removing sometimes the clips stay together and come out completely if that makes sense.That’s kind of weird I haven’t had any issues getting them to snap in. They have some flex to them after attached, so not sure if your comment on being tight is expectations? They definitely need to be lined up perfectly.
A couple of mine pull out of the metal and stay together as well. I’ll undo them then put the pieces back where they go before install. Then check to make sure they are all in the open position.Thanks- I’ll keep playing with it. Do you always separate the two pieces or just keep it attached to the panel and insert into the body? When removing sometimes the clips stay together and come out completely if that makes sense.
The ones that pull out from the body and don’t unsnap are broken. At least mine were. I’ve replaced a few.Thanks- I’ll keep playing with it. Do you always separate the two pieces or just keep it attached to the panel and insert into the body? When removing sometimes the clips stay together and come out completely if that makes sense.