- Thread starter
- #1
Before and after pics of the Bestop fender flares.
Sponsored
They definitely aren't easy on/off. They are installed with a combo of bolts/clip using factory mounting holes and 3m tape.I really like them. I'm just not sure that I like them $600 worth .
Was the install bolt on/clip on only? Or did you need to use double sided tape on the install? I might go for these, if they are reasonably easy on/easy off, so I could go back to the OEM flares if I ever wanted to.
The square look almost makes it seem like you also added a small lift. Not bad at all!
I've been shocked at how tiny a Jeep looks next to a Bronco.Congratulations on your new Jeep!
They look awesome do they add any additional tire coverage
No. They are actually a lot closer to the body than the stock flares.They look awesome do they add any additional tire coverage
I can't wait to see this done, that weird arch is the big thing holding me back. There's no going back afterwards though.Cut out the rounded part and
One was built for tight trails. The other was built for wide open desertThe square look almost makes it seem like you also added a small lift. Not bad at all!
I've been shocked at how tiny a Jeep looks next to a Bronco.
Don't think that is possible. The metal fender is still back there.@Bestop_Team - Cut the roundness out of these and I think you'll sell a whole bunch more.
Other than that, these look good!
Ah, my bad - I thought that was part of the fender design but I understand now. Damn it!Don't think that is possible. The metal fender is still back there.