Here is a side pic on my garage floor. Doesn't look to be squatting on level ground. Maybe I'm blind!
Looks great
Sponsored
Here is a side pic on my garage floor. Doesn't look to be squatting on level ground. Maybe I'm blind!
I appreciate the knowledge. Makes sense and would be great for everyone to know.Just to expand on the center axle to fender measurement.
Let's say a Base, a Badlands, and a Sasquatch all buy the same brand X coilover advertised as a 2 inch lift. To complicate things even more, the Base installs some Big Bend wheels/tires at the same time. The Badlands decides to do a fender flare delete at the same time, and the Squatch installs 37s at the same time. They all have different starting suspensions, so the amount of lift each gets will be different, but what will be fairly consistent is the center axle to fender measurement.
Now, I'm here with a Black Diamond trying to figure out how much lift I would get from the same coilover, all I have to do is measure my current axle to fender measurement and compare. Getting their ground to flare height really wouldn't tell me much unless I was going to the same flare/wheel/tire combo as well.
Or, another scenario is I want to find out how much lift I'd get from brand X 2 inch coilovers, but I have a heavy winch and plate bumper. All I have to do is find someone using the same coilovers with a comparable setup and get their axle to fender measurement to have a good estimate of what mine would be with those coilovers.
Purchased directly thru Eibach for $380, $415 deliveredFrom all the pictures it looks like the perfect amount of lift. Going to go with these over perch collars while I wait for coilovers. Anybody know of any deals going on for them?
So these first two were both recommended in this thread, which one is better? How about the 3rd one?
So these first two were both recommended in this thread, which one is better? How about the 3rd one?
An amazon compressor might work provided its not the threaded rod style no chance there. The eibach fronts are pretty stiff and you have to compress them pretty far to get into the factory strut. If the spring compressor bends, slips, or breaks with that much pressure on it I wouldn't want to be anywhere near it.Well crap....so my Amazon ones won't work? I've used them on multiple cars in the past, even on my XJ.
Are these really that strong?
An amazon compressor might work provided its not the threaded rod style no chance there. The eibach fronts are pretty stiff and you have to compress them pretty far to get into the factory strut. If the spring compressor bends, slips, or breaks with that much pressure on it I wouldn't want to be anywhere near it.
https://www.bronco6g.com/forum/thre...2-0-lift-installed-on-badlands-non-sas.51430/Anyone bite the bullet and try these on a non-SAS Badlands?
Thanks but looking for just the coil install, NOT the coil over.
I'm confused. Maybe this has been covered, but are the springs only lift springs for 4dr only? or for 2.7 only? Or does it not matter? Has anybody installed them on a 2.3L 2dr? Website does not list them for that combo.