You cannot be thanked enough for doing this!!I ended up running the positive and ground wire all the way from the engine bay down the frame to the rear axle following the existing harness the best I could. Being a two door I would guess I used 20 feet of wire plus or minus some.
I installed a grommet to protect the wire coming through the metal hole, and the rest is incased in plastic wire loom to keep it safe.
Down the firewall to along the frame.
Up and over in the rear still somewhat following the original harness.
Still following the original loom, but here is where I installed the heat shielding like Ford does from the Factory.
Final curl into the axle.
I put my suspension through the full range of motion and never had any tension on the wire or pinch points.
I originally though of using the factory wire ran to the rear of the cabin, but didn't know if there was a pass through to get it out and under to the axle.
Sponsored